Automotive Refinishing and Body Shops
The Drying Rack Built for Auto Body Shops
Stop losing booth time to mismatched panels and parts waiting on the floor. FlexiRacks keeps your refinishing department organized and your bays moving.
The Challenge
What Slows Down Your Finishing Department
Every Job Has Mixed Panel Sizes
A collision job rarely comes in uniform. A bumper cover, a door skin, and a hood need to dry at the same time, but standard fixed-width racks cannot handle all three without parts overhanging, shifting, or touching each other. Shops end up spreading panels across benches, saw horses, and any available surface just to keep them apart.
Racks Take Over the Floor Between Jobs
Bulky drying equipment with no storage solution stays in the middle of the bay long after parts are dry. Moving it requires effort, and most fixed racks cannot nest or collapse, so they occupy prime floor space your team needs for vehicle movement and bay turnover throughout the day.
Paint Gets Marked Before It Cures
A freshly cleared panel is easy to damage. Racks with bare metal bars or tight fixed spacing risk contact the moment a wet panel is loaded, leaving marks, pressure points, or smudges on surfaces that were just finished and requiring costly rework before delivery.
The Solution
How FlexiRacks Keeps Your Body Shop Moving
One Rack for the Whole Job
The sliding central post adjusts and locks at any position from 2.5 to 55 inches without tools. Load a bumper cover, a door, and a fender on the same rack in the same session no separate equipment needed, no compromise on how parts sit. For oversized panels like hoods or trunk lids that need more room, remove any holding bar in seconds to open up the exact space the part requires.
Reclaim Your Bay Floor in Seconds
When the rack is not in use, FlexiRacks nest inside each other in the footprint of a single unit. No folding mechanisms, no heavy lifting, no wall-mounted storage systems. Push them together, and your bay floor is clear immediately, ready for the next vehicle. Read more about Compact Nesting Storage
Rubber-Coated Bars Protect Every Panel
Every FlexiRacks holding bar is coated in rubber, resistant to conventional paints, lacquers, primers, oils, and water-based finishes. The standard 3-inch spacing between levels gives fresh panels safe loading clearance without touching the bar above. Remove any bar without tools to create additional clearance for thicker or larger components anywhere on the rack.
Recommended Racks
Recommended Racks for Auto Body Shops
Select the configuration that fits your space, workflow, and drying needs.
