Woodworking and Cabinet Shops
The Industrial Drying Rack Built for Cabinet Shops
Stop losing production time to scattered parts and floor space taken over by drying doors. FlexiRacks keeps your finishing department organized and your shop moving.
The Challenge
What Slows Down Your Finishing Department
Production Comes to a Halt
When cabinet doors need to dry after finishing, everything else stops. Doors scatter across benches, table saws, and flat surfaces because there is no dedicated drying system. The shop loses hours every finishing day waiting for space to clear.
Tight Rack Spacing Damages Fresh Finishes
Most drying racks on the market have fixed narrow spacing between levels. When you slide a freshly painted door onto the rack, the wet surface risks touching the level above — leaving marks, smudges, and requiring costly rework on parts that were just finished.
One Rack Cannot Handle Mixed Part Sizes
A typical cabinet job includes face frames as narrow as a few inches and full doors up to 25 inches wide. Fixed-width racks force you to compromise — wide parts overhang and narrow parts shift and fall. Shops end up needing multiple racks for the same job.
How FlexiRacks Keeps Your Shop Moving
The Solution
Keep the Shop Floor Clear
Parts load directly from the spray booth onto the rubber-coated holding bars. They rest horizontally across the bars with air circulating freely on all sides. Benches, saws, and machinery stay clear and your team keeps working while parts dry.
3-Inch Spacing Protects Every Finish
FlexiRacks uses 3 inches of vertical spacing between every level, enough clearance to slide freshly painted doors onto the rack without the wet surface touching the bar above. When you need even more space for thicker parts like drawer boxes, simply remove any bar and create the gap you need.
One Rack for Your Full Part Range
The sliding central post adjusts and locks at any position from 2.5 inches to 25 inches without tools. One rack handles face frames, drawer fronts, and full cabinet doors in the same loading session without reconfiguring. No separate equipment for different part widths.
Recommended Racks
Recommended Racks for Cabinet Shops
Select the configuration that fits your space, workflow, and drying needs.
Why FlexiRacks
Built for the Way Cabinet Shops Work
Rubber-Coated Bars
Other racks have no protective coating, forcing shops to wrap bars with foam or sponge that collects sawdust and paint residue. Every FlexiRacks holding bar is coated in rubber that protects freshly painted and finished surfaces from any metal contact. Resistant to conventional paints, varnishes, oils, waxes, and water-based finishes. Read more about holding bar protection
3-Inch Vertical Spacing
The standard 3-inch spacing between levels gives you safe loading clearance for freshly painted doors. Need more space for thicker parts like drawer boxes? Remove any holding bar without tools to instantly double or triple the gap at any position on the rack. No spanners, no drill, no tools required. Read more about spacing adjustment
Sliding Central Post Width Adjustment
The central post slides horizontally and locks at any position from 2.5 inches to 25 inches without tools. Adjust in seconds to fit any part width in your current production run. One rack, one adjustment, ready to load. Read more about width adjustment
Compact Nesting Storage
When finishing is complete, FlexiRacks nest inside each other in the footprint of a single unit. No heavy lifting, no complex folding, no floor space wasted between production runs. Move them to the wall and reclaim your shop floor immediately. Read more about Compact Nesting Storage